User's Manual

Prepare to use your Bluetooth headset
1. Charging and battery time
Before use your headset, you need to fully charge the battery.
NOTE: When the headset is under charging, it stays on “OFF” mode. You’ll need to turn “ON” the headset to
use after the charging.
A. Connect the adaptor into an electrical outlet.
B. Plug the adaptor's connector into charging port.
C. While charging, the blue indicator light will stay solid on, when charging is completed, the light will be off.
Then you can take the adaptor's connector out from the headset and disconnect the adaptor from the
electrical outlet.
D. Charging time is about 2.5-3 hours.
When charging the headset please follow the arrow angle to insert the adaptor’s connector to headset, avoid
vertical insert
Note: The ear hook socket port and the power charging port is the same, it means you can either use
one port to insert the ear hook, while the other port to charging the battery.
2. Linking the headset to the phone (Pairing)
Before you use your headset for the first time, you must pair the headset to a Bluetooth phone. The Bluetooth
connection between the headset and your phone can be established by setting up a paired link. With a paired
link, the phone remembers the headset's ID, and process with future use.
3. Pairing the headset to the phone
Before you can pair your headset you need to put it into pairing mode.
Note: Pairing must be done every time while the headset establishes a link with a different Bluetooth phone.
Pairing mode can only be entered from the power OFF state. During pairing, it is recommended that the
headset and phone distance is as close as possible with no solid objects in between.
To proceed pairing the headset with the bluetooth phone, please follow this guide:
A. Check the mobile phone user guide, and then find out the locations of Bluetooth device discovery.
B. Ensure headset is switched off.
C. Press and hold the Talk button for about 3 seconds, blue LED blinking 5 times, keep pressing, then blue
LED and red LED is cross blinking. This means the headset is in pairing mode.
D. Perform a Bluetooth device discovery from the mobile phone. NOTE: It may take several seconds to
establish connections.
E. The phone's display will advise that it has found HUGES-M303 and ask you to confirm that you want to
pair with it. Confirm this.
F. Enter the passkey 1234, when your phone menu prompts you, and the phone will start to pair the
headset.
G. Your phone screen will advise that pairing has been successful, and the blue indicator on your headset
will flash once every 3 sec. when Bluetooth pairing has been established.
If the pairing fails, the blue LED and red LED keep cross blinking and keep about 60 sec. then stop. A
re-pairing procedure is needed. Please refer to above A. ~ G.
NOTE: Your phone screen will also give the status. Once the headset and phone have successfully paired
you are ready to place and receive calls.
Turning your headset ON and OFF
To switch your headset on, press and hold Talk button for about 3 seconds, the blue LED lights 5 times,
release the button. The blue LED will be then blinking once every 3 seconds. This is standby mode which
means the headset is awaiting a call.
To switch your headset off, press and hold Talk button for 3 seconds until there are 5 times red LED blinking,
release the button.