User's Manual

Making a call with the headset
There are different ways to make a call using your headset as the following description.
NOTE: Make sure the headset and the cell phone are under link stage. For the examples of Ericsson and
Nokia cell phones, the
and symbols mean "link" status. For Nokia cell phone, it is necessary to press
the talk button once to make the
symbols on the cell phone when the headset is out of 10 meters, power
off or after charging.
If your bluetooth phone supports voice dialing, you can use this feature with the headset. Please refer to your
phone's user guide for more information on voice control.
Making a call from the mobile phone
1. Place the headset on your ear in the desired wearing style.
2. Using the phone's keypad, dial the phone number.
3. To send the call, press the phone's SEND/CALL key the phone initiates the all.
4. The call will then transfer automatically to the headset when connection is made.
Note: When making call from Siemens S55 phone, please press the talk button on the headset. (New version
headset will modify this issue.)
Making a call using voice dialing
1. Voice dialing to your phone must be turned on and voice tags stored.
2. Place the headset in the desired wearing style.
3. Press the talk button on the headset.
4. A short tone will prompt you and you can speak the voice “tag” name as entered in the phone’s voice dial
phone book.
5. The phone automatically dials your selection, and you see the details of the call on the phone screen.
6. When connected, you are free to communicate normally by the headset.
Note: Please refer to the phone user guide for instructions on storing voice tags.
Ending a call from the headset
To end a call; when wearing the headset press the headset's Talk button.
Or you can end the call from the phone key pad.
Or when the other side hangs up the phone, the call ends automatically.
Receiving/Answering a call
If there is an incoming call while you are wearing the headset, a ring tone will sound in your headset and just
press the headset's Talk button to answer the call.
If you are not wearing the headset, then place the headset on your ear in the normal wearing position and use
the Talk button to accept the call.
If your cell phone supports auto answering a call, the headset will take the incoming call and you don't need to
press any button.
Note: Some old version of Sony Ericsson P800 phone could not heard ring tone from headset; please press
the talk button on the headset to answer the call. (New version P800 has no problem.)
New version headset will modify old P800 issue.
Transferring a call
To transfer a call from the phone to the headset, press the headset Talk button. To transfer a call from the
headset to the phone, switch the headset off.
NOTE: This could vary according to different cell phones model.
Speaker volume and volume control button
Headset offers adjust of speaker volume by press the volume up or down button. You can adjust the volume
to 15 pre-set levels.
Volume up and volume down button will regulate the volume to the speaker in these 15 steps. One step per
key press increases / decreases the desired volume until a satisfactory level is reached. An audible tone is
played for each step +/- and when either the minimum or maximum volume has been achieved.
Low battery warning
The headset needs re-charging when the red indicator is blinking once every about 3 sec. You can also hear