User's Manual

Then you can take the adaptor's connector out from the headset and disconnect the adaptor from the
electrical outlet.
D. Charging time is about 2.5-3 hours. (Note: First time use, please charge at least 12 hours)
2. Linking the headset to the phone (Pairing)
Before you use your headset for the first time, you must pair the headset to a Bluetooth phone. The Bluetooth
connection between the headset and your phone can be established by setting up a paired link. With a paired
link, the phone remembers the headset's ID, and process with future use.
3. Pairing the headset to the phone
Before you can pair your headset you need to put it into pairing mode.
Note: Pairing must be done every time while the headset establishes a link with a different Bluetooth phone.
Pairing mode can be entered by 2 methods:
One: When you charge the headset, the headset will automatically enter pairing mode. It will directly enter the
blow C. stage. Or
Two: Enter from the power OFF state. You will need to start from the below B. stage.
NOTE: During pairing, it is recommended that the headset and phone distance is as close as possible with no
solid objects in between.
To proceed pairing the headset with the bluetooth phone, please follow below stages:
A. Check the mobile phone user guide, and then find out the locations of Bluetooth device discovery.
B. Ensure headset is switched off.
C. Press and hold the button on headset for 3 seconds, the blue LED rapid flashing. This means the headset
is in pairing mode.
D. Perform a Bluetooth device discovery from the mobile phone. NOTE: It may take several seconds to
establish connections.
E. The phone's display will advise that it has found HH311 and ask you to confirm that you want to pair with it.
Confirm this.
F. Enter the passkey 1234, when your phone menu prompts you, and the phone will start to pair the headset.
G. Your phone screen will advise that pairing has been successful, and the blue LED on your headset will
change state, it will flash once every 3 sec. when Bluetooth pairing has been established.
If the pairing fails, the blue LED keep rapid flashing for about 2 minutes, then stop. A re-pairing procedure is
needed. Please refer to above A. ~ G.
NOTE: Your phone screen will also give the status. Once the headset and phone have successfully paired,
you are ready to place and receive calls.
Turning your headset ON and OFF
To switch your headset on, press the button for about 3 seconds, the blue LED rapid flashing, release the
button. The headset power is turn ON. After 2 minutes, the LED will slow flash; indicate headset is awaiting a
call.
To switch your headset off, press and hold the button for 3 seconds until there are 5 times blue LED flashing,
then release the button. You will find no LED indication.
Making a call with the headset by voice dialing
If your bluetooth phone supports voice dialing, you can use this feature with the headset. Please refer to your
phone's user guide for more information on voice control.
1. Voice dialing to your phone must be turned on and voice tags stored.
2. The headset power is ON.