User's Manual

3. Press the button once on the headset.
4. A short tone will prompt you and you can speak the voice “tag” name as entered in the phone’s voice dial
phone book.
5. The phone automatically dials your selection, and you see the details of the call on the phone screen.
6. When connected, you are free to communicate normally by the headset.
NOTE: Make sure the headset and the cell phone are under link stage. For the examples of Ericsson and
Nokia cell phones, the
and symbols mean "link" status. For Nokia cell phone, it is necessary to press
the bigger button once to make the
symbols on the cell phone when the headset is out of 10 meters,
power off or after charging.
Making a call from the mobile phone
1. Using the phone's keypad, dial the phone number.
2. To send the call, press the phone's SEND/CALL key the phone initiates the all.
3. The call will then transfer automatically to the headset when connection is made.
Ending a call from the headset
To end a call, press the button on headset.
Or you can end the call from the phone key pad.
Or when the other side hangs up the phone, the call ends automatically.
Receiving/Answering a call
If there is an incoming call, a ring tone will sound in your headset; just press the button on headset to answer
the call.
If your cell phone supports auto answering a call, the headset will take the incoming call and you don't need to
press any button.
Speaker volume control button
To adjust the volume of headset, you may use phone’s volume up down buttons to adjust the headset volume.
Low battery warning
The headset needs re-charging when the blue LED is quick flash 6 times every 3 sec. You can also hear a
special tone of DO-LU-DO-LU-DO from the headset every about 40 sec.
Once the low battery warning starts, there will be around 10 minutes talk time left, charging the headset is
necessary.
Audio and visual indicators
Visual LED chart:
Headset state LED indication state Remark
Standby Flash 1 time every 3 seconds In headset profile
Flash 3 times every 3 seconds In handsfree profile
Initial a call (Use voice dial) Flash 2 times every 3 seconds
During a call Flash 4 times every 3 seconds
Power on/off Flash 5 times every 3 seconds
Low battery Flash 6 times every 3 seconds
Pairing LED rapid flashes for 2 minutes Each time turn power on and charging
headset will automatically enter the
pairing
Audio indicator chart:
Headset state Audio indication
Volume button Repeated single tone when the button either lower
or upper is pressed.
Incoming call Ring tone
Low battery DO-LU-DO-LU-DO tone every 40 sec.
Initiate voice dial Headset rings as cell phone default sound.