User's Manual

3
the headset's ID, and process with future use.
3. Pairing the headset to the phone
Before you can pair your headset you need to put it into pairing mode.
Note: Pairing must be done every time while the headset establishes a link with a different Bluetooth phone. Pairing mode
can only be entered from the power OFF state. During pairing, it is recommended that the headset and phone distance is as
close as possible with no solid objects in between.
To proceed pairing the headset with the bluetooth phone, please follow this guide:
A. Check the mobile phone user guide, and then find out the locations of Bluetooth device discovery.
B. Ensure headset is switched off.
C. Press and hold the Talk button for about 3 seconds, blue LED blinking 5 times, keep pressing, then blue LED and red
LED is cross blinking. This means the headset is in pairing mode.
D. Perform a Bluetooth device discovery from the mobile phone. NOTE: It may take several seconds to establish
connections.
E. The phone's display will advise that it has found HUGES-HH303 and ask you to confirm that you want to pair with it.
Confirm this.
F. Enter the passkey 1234, when your phone menu prompts you, and the phone will start to pair the headset.
G. Your phone screen will advise that pairing has been successful, and the blue indicator on your headset will flash once
every 3 sec. when Bluetooth pairing has been established.
If the pairing fails, the blue LED and red LED keep cross blinking and keep about 60 sec. then stop. A re-pairing procedure is
needed. Please refer to above A. ~ G.
NOTE: Your phone screen will also give the status. Once the headset and phone have successfully paired you are ready to
place and receive calls.
Turning your headset ON and OFF
To switch your headset on, press and hold Talk button for about 3 seconds, the blue LED lights 5 times, release the button.
The blue LED will be then blinking once every 3 seconds. This is standby mode which means the headset is awaiting a call.
To switch your headset off, press and hold Talk button for 3 seconds until there are 5 times red LED blinking, release the
button.
Making a call with the headset
There are different ways to make a call using your headset as the following description.
NOTE: Make sure the headset and the cell phone are under link stage. For the examples of Ericsson and Nokia cell phones,
the
and symbols mean "link" status. For Nokia cell phone, it is necessary to press the talk button once to make the
symbols on the cell phone when the headset is out of 10 meters, power off or after charging.
If your bluetooth phone supports voice dialing, you can use this feature with the headset. Please refer to your phone's user
guide for more information on voice control.
Making a call from the mobile phone
1. Place the headset on your ear in the desired wearing style.
2. Using the phone's keypad, dial the phone number.
3. To send the call, press the phone's SEND/CALL key the phone initiates the all.
4. The call will then transfer automatically to the headset when connection is made.
Note: When making call from Siemens S55 phone, please press the talk button on the headset.
Making a call using voice dialing
1. Voice dialing to your phone must be turned on and voice tags stored.
2. Place the headset in the desired wearing style.
3. Press the talk button on the headset.