User's Manual

4
4. A short tone will prompt you and you can speak the voice “tag” name as entered in the phone’s voice dial phone book.
5. The phone automatically dials your selection, and you see the details of the call on the phone screen.
6. When connected, you are free to communicate normally by the headset.
Note: Please refer to the phone user guide for instructions on storing voice tags.
Ending a call from the headset
To end a call; when wearing the headset press the headset's Talk button.
Or you can end the call from the phone key pad.
Or when the other side hangs up the phone, the call ends automatically.
Receiving/Answering a call
If there is an incoming call while you are wearing the headset, a ring tone will sound in your headset and just press the
headset's Talk button to answer the call.
If you are not wearing the headset, then place the headset on your ear in the normal wearing position and use the Talk button
to accept the call.
If your cell phone supports auto answering a call, the headset will take the incoming call and you don't need to press any
button.
Transferring a call
To transfer a call from the phone to the headset, press the headset Talk button. To transfer a call from the headset to the
phone, switch the headset off.
NOTE: This could vary according to different cell phones model.
Speaker volume and volume control button
Headset offers adjust of speaker volume by press the volume up or down button. You can adjust the volume to 15 pre-set
levels.
Volume up and volume down button will regulate the volume to the speaker in these 15 steps. One step per key press
increases / decreases the desired volume until a satisfactory level is reached. An audible tone is played for each step +/- and
when either the minimum or maximum volume has been achieved.
Low battery warning
The headset needs re-charging when the red indicator is blinking once every about 3 sec. You can also hear a special tone of
DO-LU-DO-LU-DO from the headset every about 40 sec. When you talk by the headset under battery low situation, the
headset red LED is blinking 4 times every about 3 sec.
Once the low battery warning indicator starts, you have around 10 minutes of talk time left and you will then need to charge
the battery in the headset.
Audio and visual indicators
Visual Indicator chart:
Headset state LED indication state
Power Off LED off
Stand by mode Blue LED flash once every 3 sec.
Charging in process Blue LED steady on
Charging complete LED off
Low power Standby: red LED flashes once every 3 sec.
Talk: red LED flashes 4 times every 3 sec.
Pairing mode Blue LED and red LED cross flash