User's Manual

5
Pairing success Blue LED flash once every 3 sec.
Active / on call Blue LED flash 4 times every 3 sec.
Audio indicator chart
Headset state Audio indication
Volume button Repeated single tone when the button either lower or upper is pressed.
Incoming call Ring tone
Low battery DO-LU-DO-LU-DO tone every 40 sec.
Initiate voice dial the headset rings as the cell phone default sound.
Bluetooth headset specification
Bluetooth compliance Bluetooth 1.1 with headset profile
Bluetooth power 0 dbm
Maximum cordless distance 30 Feet (10 meters)
Weight of headset 18.5g
Typical standby time 168 hours
Typical talk time 5 ~ 7 hours
Typical re-charge time 2.5-3 hours
Battery type Li polymer rechargeable (88mA)
NOTE: Talk time and standby time are varied according to different mobile phones.
Storage of headset
1. Always store the headset and audio gateway safety protected.
2. Avoid storage at high temperatures (above 60 C/134 F) such as in a hot vehicle or in direct sunlight. (Storage at high
temperature can degrade performance and reduce battery life.)
3. Do not expose the headset and audio gateway or any of its supplied parts to rain or other liquids.
Certification and safety approvals/general information
This product is CE, FCC, BQB marked. Please note that this product uses radio frequency bands not
harmonized within EU. Within the EU, this product is intended to be used in Austria, Belgium, Denmark,
Finland, France, Germany, Greece, Ireland, Italy, Luxembourg, The Netherlands, Portugal, Spain,
Sweden, United Kingdom and within EFTA in Iceland, Norway and Switzerland.
Users are not permitted to make changes or modify the device in any way. Changes or modifications not
expressly approved by your distributor will void the users' authority to operate the equipment.
Bluetooth is a trade mark owned by Bluetooth SIG, Inc.
Caution:
Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
Important information on safe and efficient operation. Read this information before using your phone.
Users are not permitted to make changes or modify the device in any way. Changes or modifications not
expressly approved by the party responsible for compliance could void the user's authority to operate
the equipment.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.