Technical data
english
BassKick 200 & 300
BassKick 200 & 300
9 Technical Data
Security Specifications
Mains input voltages: 240V, 220-230V, 117V, 100V
BK 200 BK 300
Primary fuses: 240V T1,25A T2A
220-230V T1,25A T2A
117V T2,5A T4A
100V T2,5A T4A
Secondary fuses: 2 xT3,15A 2 xT4A
Power consumption: 370 watts 615 watts
Ambient air temperature in operation: 0-35 degrees Celsius
Inputs
INST. INPUT passive: Socket: Jack, unsymmetrical
Input impedance: 1 MOhm
Sensibility: - 22 dBV
max. input level: + 2 dBV
INST. INPUT active: Socket: Jack, unsymmetrical
Input impedance: 1 MOhm
Sensibility: - 11,5 dBV
max. input level: + 13,5 dBV
FX LOOP-Return: Socket: Jack, unsymmetrical
Input impedance: 48 kOhm
max. sensibility: - 10 dBV
max. input level: +6,5 dBV
Outputs
FX LOOP-Send: Socket: Jack, unsymmetrical
Output impedance: 220 Ohm
Output level: - 6 dBV
LINE OUT: Socket: XLR male, symmetrical
Output impedance: 1.8 kOhm
Output level: + 4 dBV
Headphones: Socket: Stereo jack
Impedance: 8-200 Ohm
Speaker: Socket: Jack, unsymmetrical
Impedance: 4-8 Ohm
Speaker equipment: 1 x 15" Eminence Bass, 4 Ohm
1 x Leson ceramics tweeter, 4 Ohm
Cutoff frequency: 5 kHz
Dimensions (w,h,d) and weight:
BK 200 BK 300
Dimensions: 551 x 604 x 385 mm 611 x 625 x 385 mm
Weight: 32 kg 36 kg
70 lbs 80 lbs
The amp is too quiet.
• A device that is operated in the loop causes level losses. The effects
pedal must be levelled by means of its input/output controller.
The amp sounds too dull
• The tweeter is switched off
8 Maintenance and care
The BassKick™ amps are maintenance-free. There are, however, some
basic rules, the compliance with which secures the high useful life of
your amp:
• Do always provide for a technically unobjectionable device periphery!
• Do always provide for free air circulation at the cooling surface of
your amp.
• Do in any case avoid heavy mechanical shocks, extreme heat and
the permeation of dust and moisture.
• Do meticulously observe the specifications of additional devices.
Do never connect outputs with too large levels (e.g. power
amplifiers) to the inputs of the amp.
• Do always check the existing mains voltage before connecting
the amp to the mains supply. In case of doubt, contact the stage
technician, caretaker or similar persons.
• Please do never try to repair your amp yourself! Even the exchange
of internal fuses should be carried out by an experienced technician
only.
• The housing surface or the metal surfaces are at best cleaned with a
soft dry cloth. Do in no case use alcohol or other solvents!
9
basskick200_300_bda.indd 9 13.11.2006 09:43:54