.0 22.05.2001 15:11 Uhr Seite 1 BEDIENUNGSANLEITUNG M ANUA L ENGLISH ProjectorManual 1.
ProjectorManual 1.0 22.05.2001 15:11 Uhr Seite 5 Table of Contents WELCOME TO THE HK AUDIO FAMILY! 1. Congratulations on choosing PROJECTOR, a three-way active sound reinforcement system with the power of a large PA and the advantages of state-of-art active electronics. Not only is it easy to transport, you’ll also find that it takes no time at all to set up and connect PROJECTOR.
ProjectorManual 1.0 22.05.2001 15:11 Uhr Seite 6 PROJECTOR MANUAL 1. PROJECTOR SYSTEM COMPONENTS 1.1 MID-HIGH UNIT MID THROW SIGNAL/ SOFT LIMIT/ FULL LIMIT -6 dB MID THROW 0 dB ON LIFT LONG THROW INPUT THROUGH GAIN HF MF GROUND LONG THROW SELF-POWERED LONG THROW SYSTEM ® PROJECTOR MADE IN GERMANY 600 W RMS MID-HIGH UNIT MAINS INPUT NRTL (Fairfield) UL 6500 POWER NRTL (Fairfield) UL 6500 ON CAUTION! OFF 117 V~ 6.0 A 50 - 60 HZ MAX.
ProjectorManual 1.0 22.05.2001 15:11 Uhr Seite 7 PROJECTOR MANUAL 1.2 SUB 1 and SUB 2 6. VENTILATION UNIT This ventilating fan keeps the power amp modules cool. Always make sure that the fan and the ventilation vents are kept free of dirt and debris and that they remain unobstructed so air can circulate freely.
ProjectorManual 1.0 22.05.2001 15:11 Uhr Seite 8 PROJECTOR MANUAL 2. SETTING UP THE SYSTEM 2.1 Standard System Setup/Stacking: SUB 1 – SUB 2 – MID-HIGH UNIT! Here’s how you set up the standard system configuration: Always set up the cabinets as illustrated in the diagram. Set SUB 1 on the floor, SUB 2 on SUB 1, and the MID-HIGH UNIT on top of the stack. In this configuration, the subwoofers form a full horn and provide the greatest possible output. 2.
ProjectorManual 1.0 22.05.2001 15:11 Uhr Seite 9 PROJECTOR MANUAL To mount the Tilt Unit, proceed as follows: 2.3 Flying the Mid-High Units 1. Set the PROJECTOR system up as described above The PROJECTOR MID-HIGH UNITS are equipped with three eightposition Aeroquip flight rails that allow the cabinets to be flown (i.e. allow the cabs to be hung from a cross beam or flight rig). These rails are designed to be used with steel cables that are available as an optional accessory.
ProjectorManual 1.0 22.05.2001 15:11 Uhr Seite 10 PROJECTOR MANUAL 3. CONNECTING CABLES 4. POWERING UP The integrated design of the PROJECTOR system minimizes the effort involved in connecting cables. Turn the GAIN knob on the cabinets all the way down (counterclockwise as far as the knob will go). Make sure that the entire system is connected before you power it up and that all connected peripheral components are already in operation.
ProjectorManual 1.0 22.05.2001 15:11 Uhr Seite 11 PROJECTOR MANUAL 1. Don’t expose electronic circuitry to moisture! When you set the system up outdoors, be sure to protect it against rain. Keep soft drinks, beer or any other liquids well away from the cabinets to protect their electronic components from short circuits. 2. To assure proper ventilation, make sure that cabinets are placed a sufficient distance away from walls and aren’t covered by curtains and the like.
ProjectorManual 1.0 22.05.2001 15:11 Uhr Seite 12 PROJECTOR MANUAL 8. SAFETY INSTRUCTIONS FOR FLYING THE SYSTEM PROJECTOR MID-HIGH Installation Instructions According to TÜV Directives TÜV (Technischer Überwachungsverein) is Germany’s safety standards authority. These instructions explain the installation procedure for HK AUDIO PROJECTOR MID-HIGH speaker cabinets equipped with Aeroquip rails. The following steps are in strict adherence with TÜV installation specifications.