User's Manual
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Installation summary
- Ch 2 - Prerequisites
- Ch 3 - Indoor equipment
- Ch 4 - Installing IFL cables
- Ch. 5 - Installing mast mounts
- Ch 6 - Installing ODUs
- Ch 7 - Commissioning the RT
- Ch 8 - Final steps
- Ch 9 - Troubleshooting
- Ch 10 - Maintenance
- App A - Acronyms
- App B - Standards compliance
- App C - Terminating the IFL cable
- Index
1027144–0001 Revision D
Installing ODUs 6–17
RT installation
To adjust the antenna elevation (upward or downward pointing
direction), you rotate the antenna upward or downward, as
illustrated in figure 6-16, until the elevation is set as desired.
T0009030
Antenna
(front)
Side view
0elevation°
Downward
elevation
Upward
elevation
Figure 6-16 Antenna elevation adjustment
(upward or downward adjustment)
You adjust the antenna elevation in two stages:
1. Coarse adjustment, using the built–in antenna boresight
(steps 1 and 2, on page 6–18).
2. Electronic pointing, using a voltmeter and integrated system
software (section 7.4). This procedure, a part of the RT
commissioning process, refines the elevation adjustment to
point the antenna as accurately as possible.
6.7
Initial (coarse)
antenna elevation
adjustment