User's Manual
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Installation summary
- Ch 2 - Prerequisites
- Ch 3 - Indoor equipment
- Ch 4 - Installing IFL cables
- Ch. 5 - Installing mast mounts
- Ch 6 - Installing ODUs
- Ch 7 - Commissioning the RT
- Ch 8 - Final steps
- Ch 9 - Troubleshooting
- Ch 10 - Maintenance
- App A - Acronyms
- App B - Standards compliance
- App C - Terminating the IFL cable
- Index
1027144–0001 Revision D
Installing ODUs 6–21
RT installation
Follow these steps to attach the transceiver to the antenna:
1. Remove the plastic plug from the antenna waveguide and
the plastic cap from the transceiver coupling.
CAUTION
Always keep the waveguide and coupling
plugs in place when the transceiver is
detached from the antenna, to prevent
contamination.
2. Position the transceiver so its four mounting bolts are
aligned with the four grooves on the antenna flange, as
shown in figure 6-21.
Transceiver
Mounting bolt
(Attached to transceiver
)
Antenna flange
Waveguide
Flange groove
Antenna
T0009010
Figure 6-21 Aligning the transceiver mounting bolts
6.9
Attaching the
transceiver to the
antenna