User's Manual
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Installation summary
- Ch 2 - Prerequisites
- Ch 3 - Indoor equipment
- Ch 4 - Installing IFL cables
- Ch. 5 - Installing mast mounts
- Ch 6 - Installing ODUs
- Ch 7 - Commissioning the RT
- Ch 8 - Final steps
- Ch 9 - Troubleshooting
- Ch 10 - Maintenance
- App A - Acronyms
- App B - Standards compliance
- App C - Terminating the IFL cable
- Index
1027144–0001 Revision D
Commissioning the RT 7–9
RT installation
frequency as one of the available choices. You will not be
able to proceed until the correct ODU is installed.
6. Press ENTER when the LCD shows the correct frequency,
for example:
Freq Set
8B4
Go to the roof and proceed with steps 7 through 12.
While you are pointing the antenna, the LCD shows
Freq Acq in Prog (frequency acquisition in progress).
When the RT acquiress the HT frequency, the LCD shows
Acq Ack: HT 2 (acquisition acknowledged—in this
example, frequency acquired from HT 2).
Follow these steps to fine–tune the azimuth and elevation
adjustments made when the antenna was installed (sections 6.6
and 6.7).
7. Take the digital voltmeter and torque wrench (with deep
socket) to the ODU.
8. Make sure the azimuth and elevation locking nuts on the
antenna mount are loose—just loose enough to allow the
antenna to rotate (for elevation adjustment) and move in
azimuth. These nuts are shown in figure 7-5.
Figure 7-5 Azimuth and elevation locking nuts
T0009033
Elevation
locking nut
Elevation
locking nut
Azimuth
locking nut
Azimuth
locking nut
Voltmeter pointing and
final adjustments