User's Manual
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Installation summary
- Ch 2 - Prerequisites
- Ch 3 - Indoor equipment
- Ch 4 - Installing IFL cables
- Ch. 5 - Installing mast mounts
- Ch 6 - Installing ODUs
- Ch 7 - Commissioning the RT
- Ch 8 - Final steps
- Ch 9 - Troubleshooting
- Ch 10 - Maintenance
- App A - Acronyms
- App B - Standards compliance
- App C - Terminating the IFL cable
- Index
1027144–0001 Revision D 7–14 Commissioning the RT
RT installation
Use the LCD Status option to check the status of the CCM, SSIs,
and ODU, as explained in the following sections.
Note: You can only perform the CCM, SSI, and ODU status
checks after the HT has been acquired.
Check the CCM status as follows:
1. Press ENTER on the CCM front panel.
The LCD shows:
Main Menu
Install
2. Use the NEXT button to scroll to:
Main Menu
Status
3. Press ENTER, to go to (select) the Status menu:
Status
CCM
4. Press ENTER to show the CCM status:
CCM
OK
The possible status conditions for CCMs, SSIs, and the
ODU are:
OK The component is operational.
Degraded The component is not fully operational.*
Failed The component has failed.
Unknown The CCM cannot communicate with the
component.
Action for “Failed” or “Degraded”status
If the LCD shows Failed for any component, replace the
component.
If you see Degraded during installation, replace the
component. However, if you see Degraded while the
system is operational, under some circumstances you may
not need to replace the component (for example, if a failed
port is not needed).
7.7
Checking
component status
Check CCM status