User's Manual
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Installation summary
- Ch 2 - Prerequisites
- Ch 3 - Indoor equipment
- Ch 4 - Installing IFL cables
- Ch. 5 - Installing mast mounts
- Ch 6 - Installing ODUs
- Ch 7 - Commissioning the RT
- Ch 8 - Final steps
- Ch 9 - Troubleshooting
- Ch 10 - Maintenance
- App A - Acronyms
- App B - Standards compliance
- App C - Terminating the IFL cable
- Index
1027144–0001 Revision D Maintenance 10–5RT installation
4. Loosen the four transceiver mounting bolts (shown in figure
10-2).
T0009018
Rotate transceiver to slide bolts out of grooves.
(Rotation direction depends on orientation
of antenna bracket to right or left.)
Transceiver
Mounting bolt
(Attached to transceiver
)
Antenna flange
Waveguide
Flange groove
Antenna
Figure 10-2 Removing the transceiver
5. Rotate the transceiver until the bolts slide out of the four
grooves in the antenna bracket. (The direction of rotation
depends on the orientation of the antenna bracket—to the
right or left.) If the mounting bolts will not slide into the
grooves, loosen the bolts. See figure 10-2.
Important: A mechanical attenuator may be installed
(previously) in the antenna waveguide. If an attenuator is
installed, make sure it does not get lost or misplaced. Leave
the attenuator in the waveguide.
CAUTION
Do not allow dirt, dirt, moisture, or other
contaminants to enter the waveguide.
6. Cover the transceiver coupling (center hole) with a plastic
coupling plug (if available) or tape to prevent
contamination.