User's Manual
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Installation summary
- Ch 2 - Prerequisites
- Ch 3 - Indoor equipment
- Ch 4 - Installing IFL cables
- Ch. 5 - Installing mast mounts
- Ch 6 - Installing ODUs
- Ch 7 - Commissioning the RT
- Ch 8 - Final steps
- Ch 9 - Troubleshooting
- Ch 10 - Maintenance
- App A - Acronyms
- App B - Standards compliance
- App C - Terminating the IFL cable
- Index
1027144–0001 Revision D 1–4 Installation summary
RT installation
Install the mast mount – page 5–4
Install the antenna mount – page 6–8
Attach the antenna to the mount – page 6–10
Adjust the antenna azimuth – page 6–14
Adjust the antenna elevation – page 6–17
Install the mechanical attenuator (if required) – page 6–19
Attach the transceiver to the antenna – page 6–21
Ground the ODU – page 6–23
Connect the IFL to the ODU – page 6–25
Connect the IFL to the CCM (IDU) – page 7–3
Point the antenna (with voltmeter) – page 7–9
Verify HT acquisition – page 7–13
Enter an attenuator value – page 7–13
Check CCM, SSI, and ODU status – page 7–14
Verify the RT’s operational state – page 7–17
Perform RT to HT connection tests – page 7–18
Weatherproof connections – page 8–2
Obtain customer signoff – page 8–3
For detailed installation instructions, see chapters 2 through 8.