User's Manual
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Installation summary
- Ch 2 - Prerequisites
- Ch 3 - Indoor equipment
- Ch 4 - Installing IFL cables
- Ch. 5 - Installing mast mounts
- Ch 6 - Installing ODUs
- Ch 7 - Commissioning the RT
- Ch 8 - Final steps
- Ch 9 - Troubleshooting
- Ch 10 - Maintenance
- App A - Acronyms
- App B - Standards compliance
- App C - Terminating the IFL cable
- Index
1027144–0001 Revision D 3–20 Installing indoor RT equipment
RT installation
If the rectifier–to–chassis power circuit does not include a suitable
circuit breaker, you can satisfy the disconnect requirement by
including a remote power–off switch as shown in figures 3-11 and
3-12. If the power circuit already includes a suitable circuit
breaker, skip this section.
1
2
3
4
5
T0006052
DC power cable
Conduit
Remote
power-off
circuit
Rectifier
IDU chassis
Ground
Figure 3-11 The remote power–off circuit (if needed) is
installed between the IDU chassis and dc power source.