User's Manual
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Installation summary
- Ch 2 - Prerequisites
- Ch 3 - Indoor equipment
- Ch 4 - Installing IFL cables
- Ch. 5 - Installing mast mounts
- Ch 6 - Installing ODUs
- Ch 7 - Commissioning the RT
- Ch 8 - Final steps
- Ch 9 - Troubleshooting
- Ch 10 - Maintenance
- App A - Acronyms
- App B - Standards compliance
- App C - Terminating the IFL cable
- Index
1027144–0001 Revision D 3–38 Installing indoor RT equipment
RT installation
7. If any chassis slots are empty, cover the slot with a blank
panel.
(If you need additional blank panels, order HNS part
1026730–0001.)
8. Connect each EIDU FEM to an IDU FEM, as illustrated in
figure 3-22.
If you are installing multiple EIDUs, you can connect any
EIDU FEM to any IDU FEM.
Use 62.5/125–micrometer multimode optical fiber cable
terminated with SC connectors to connect the FEMs. An SC
connector is shown below.
SC connector
T0009054
Connect TX to RX:
IDU TX port to EIDU RX port
EIDU TX port to IDU RX port