User's Manual
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Installation summary
- Ch 2 - Prerequisites
- Ch 3 - Indoor equipment
- Ch 4 - Installing IFL cables
- Ch. 5 - Installing mast mounts
- Ch 6 - Installing ODUs
- Ch 7 - Commissioning the RT
- Ch 8 - Final steps
- Ch 9 - Troubleshooting
- Ch 10 - Maintenance
- App A - Acronyms
- App B - Standards compliance
- App C - Terminating the IFL cable
- Index
1027144–0001 Revision D 6–10 Installing ODUs
RT installation
Follow the instructions in this section to attach the antenna to the
mount.
Before mounting the antenna, check to make sure the radome
drain groove and clamp are at the bottom of the antenna, with
respect to the position the antenna will be in when it is mounted.
See figures 6-8 and 6-9.
Drain
groove
Clamp:
20 inch-pounds
(2.3 Newton-meters)
T0009026
Figure 6-8 Radome drain groove
6.5
Attaching the
antenna to the
mount
Checking the radome
drain position