User's Manual
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Installation summary
- Ch 2 - Prerequisites
- Ch 3 - Indoor equipment
- Ch 4 - Installing IFL cables
- Ch. 5 - Installing mast mounts
- Ch 6 - Installing ODUs
- Ch 7 - Commissioning the RT
- Ch 8 - Final steps
- Ch 9 - Troubleshooting
- Ch 10 - Maintenance
- App A - Acronyms
- App B - Standards compliance
- App C - Terminating the IFL cable
- Index
1027144–0001 Revision D
Installing ODUs 6–11
RT installation
Note: The RT antenna can be rotated 180°, as shown
below, to attach to a mount to the right or left. If you rotate
the antenna this way, make sure the radome drain will be at
the bottom of the antenna, when mounted.
T0009004
Figure 6-9 The RT antenna can be rotated to attach to the right or left
If the radome drain groove is at the bottom of the antenna,
proceed to section 6.6.
If the drain groove is not at the bottom of the antenna, rotate the
radome panel as follows:
1. Using a 5/32–inch (4–millimeter) torque hex key wrench,
loosen the radome band clamp locking nut.
2. Rotate the radome panel until the band clamp and drain
groove are located at the bottom of the antenna (as it will be
mounted).
3. Tighten the radome band clamp locking nut to 20
inch–pounds torque (2.3 Newton–meters).
Changing the drain
position