Installation Manual

1027145–0001 Revision D 10–8 Maintenance Hub installation
Installing the replacement antenna
6. Install a temporary installation collar below the antenna
mount, as explained in section 4.5 (page 4–11).
You need the temporary installation collar so you can align
the replacement antenna.
7. Attach the replacement antenna to the mount, as explained
in section 4.7 (page 4–17).
8. Align the replacement antenna by adjusting the azimuth and
elevation as detailed in sections 4.8 and 4.9 (beginning on
page 4–20).
9. Attach the transceiver to the antenna, as explained in
section 4.10 (page 4–27).
10. Connect the IFL cable to the IFL connector on the
transceiver.
11. Ground the ODU, as explained in section 4.11 (page 4–30).
12. Apply power to the IDU chassis power supply (section 6.3,
page 6–11).
13. Use the CCM LCD to check the ODU status. (For details,
see section 6.10).
14. Notify the EMS operator that the HT is ready to resume
service.