Installation Manual
Table Of Contents
1027145–0001 Revision D 5–14 Installing IFL cables
Hub installation
5. Connect the cable to the RF arrestor, as shown in figure
5-10.
Figure 5-10 Connecting the IFL to the RF arrestor
hb084
Ground wire
IFL
To ODU
N connector
RF arrestor
N connector
Note: The IFL cable is connected to the IDU after the CCM and
SSIs are installed (chapter 6).
Do not apply weatherproofing compound or tape until the HT
has been tested and commissioned. Weatherproofing is
covered in section 8.1.