Installation Manual

1027144–0001 Draft – Revision D.01 7–10 Commissioning the RT
RT installation
Follow these steps to fine–tune the azimuth and elevation
adjustments made when the antenna was installed (sections 6.7
and 6.8).
7. Take the digital voltmeter and torque wrench (with deep
socket) to the ODU.
8. Using a torque wrench with a deep socket, verify that
the torque of the four mast clamp nuts on the antenna
mount is 20 foot–pounds (27.1 Newton–meters). See
figure 7-5.
Figure 7-5 Verifying torque of the mast clamp nuts
hb070
4 mast clamp nuts:
20 foot-pounds
(27.1 Newton-meters)
9. Loosen each nut by one full rotation.
(The mount stays in position, but will move when you turn
the azimuth adjuster with a wrench.)
Voltmeter pointing and
final adjustments