Installation Manual

1027144–0001 Draft – Revision D.01
Prerequisites 2–5
RT installation
Table 2-1 Tools required for RT installation – Cont’d.
(includes tools for IFL installation, antenna pointing, and initial testing)
√
Purpose (or other comments)Item
Digital voltmeter
For pointing and testing
dc voltage measurement accuracy: 0.3%
Test cable terminated with
F–connector and alligator
clips
Used to connect voltmeter to ODU for antenna
pointing
Detailed local map Used to locate the HT. Must show true north,
streets, buildings, and landmarks. Helpful if the
map shows magnetic declination (or magnetic
north versus true north). A U.S. Geological
Survey map is recommended. A travel map will
suffice if it shows sufficient detail.
Ruler or straight edge Used to mark directions on map
Pencil or broad–tip pen Used to add markings to local map
Protractor May be useful as an aid in pointing the antenna.
Must show 0° increments from 0° to 180°.
Compass May be useful as an aid in pointing the antenna.
Must be accurate to within ±1°
Personnel safety lines For safety on roof
Back brace To protect against back injury while hoisting or
lifting equipment and installation materials
Note: Vendor names, model numbers, and part numbers identify equipment known to
be suitable. Other comparable equipment may also be suitable.