Installation Manual

1027144–0001 Draft – Revision D.01 3–38 Installing indoor RT equipment
RT installation
4. Slide the FEM into the guides on each side of the chassis
slot and push it firmly into place until the front of the FEM
is flush with the front of the chassis.
rt064
CCM slot
SSI
slots
IDU
EIDU
EIDU FEM
IDU FEM
5. Tighten the thumbscrews at each end of the FEM.
To tighten the thumbscrews, push them toward the IDU
chassis and turn them clockwise. To fully tighten the
thumbscrews, use a Phillips screwdriver.
6. Repeat steps 1 through 5 for each FEM.
7. If any chassis slots are empty, cover the slot with a blank
panel.
(If you need additional blank panels, order HNS part
1026730–0001.)