Installation Manual

1027144–0001 Draft – Revision D.01 4–12 Installing IFL cables
RT installation
Figure 4-8 Connecting the IFL cable to the arrestor
rt036
Location of second arrestor,
if 2 IFLs are installed.
5. Working from inside the arrestor body, use the Sealcon
custom wrench (Sealcon part number 1.500.4200.04) to
tighten the restraining fitting to 44.2 inch–pounds.
6. Repeat steps 1 through 5 if you are installing a second IFL
cable.
Attach the lightning arrestor to the penetration sleeve:
1. Slide the lightning arrestor over the sleeve, as shown in
figure 4-9.
2. Fasten the lightning arrestor to the sleeve with a screw.
Figure 4-9 Attaching the arrestor assembly to the sleeve
rt037
Slide the lightning arrestor
over the sleeve.
Attaching the arrestor
to the penetration
sleeve