User's Manual



Using the Hughes 9

Revision 0.2

correctly, click on the ―Open Selected Connection” button. The

new context will appear in the All Active Connections field

above.

Close a Connection - In the upper field, all active connections

are shown and you can select and close any of these connections

unless an Administration Password has been enabled. See

Security Section for more information about the administration

password.

Username (UN)/Password (PW): Some Service Providers

require a username and password to be used when setting up a

connection. This is often required when using Static Global IP

addresses assigned by the Service provider. These fields can be

entered when defining a new APN or when you select a different

APN.

Automatic Context Activation (ACA)

This web page allows you to use Automatic Context Activation

(ACA) in two different ways;

 One way is to use a static IP addresses in the TE device so

you can establish an automatic PDP context with any QoS

that is offered by the network (upper half of the web page).

 The second way is to use DHCP IP addresses from the UT

so you can establish an automatic standard PDP context for

any TE that connects via DHCP to the UT (lower part of the

web page).

 You can also choose whether the context should be activated

as soon as the UT detects the device, or if the context should

only be activated when the TE attempts to send data to the

satellite link. For the ―data activated‖ option, choose ―DA‖

from the drop down list rather than just On in either static or

DHCP sections.