User's Manual



Using the Hughes 9

Revision 0.2

Telephony

You can establish ISDN data communication by connecting your

ISDN equipment directly to the BGAN Terminal‘s ISDN port

with an ISDN cable (which is the same as the Ethernet cable).

The Telephony page allows you to activate 40V power sourcing

on the ISDN interface, and configure Device MSN Settings.

General ISDN Settings:

Enable ISDN Power Sourcing: To turn on the ISDN power

sourcing, click the check box in the upper left-hand corner that

says ―Enable ISDN Power Sourcing‖ and then click on

―Apply‖. The ISDN device should receive 40V power

immediately via the ISDN cable. This field should be on

unless you never use ISDN or are using an ISDN device that

has its own power source.

Select the outgoing call type using: This box controls the

mechanism used by the terminal to select the bearer type for

mobile originated calls. By default, ―the Device Bearer

capability‖ is set as the trigger in this drop down list. Most

ISDN devices correctly signal the call type (speech, 3.1 KHz

audio, UDI, RDI) via the bearer capability.