User's Manual

Hughes 9350 BGAN Terminal User Guide 15
5. Username (UN)/Password (PW): Some Service Providers require a Username and Password to
be used when setting up a PDP context. This is often required when using Static Global IP
addresses assigned by the Service provider.
Activating a PDP Context:
To activate a PDP context, perform the following instructions:
• Do not modify the CID field unless you need to setup a specific ID for one of your
devices. Leaving it blank will allow the software to automatically choose the next CID
that is available.
• Leave the IP address field unchanged unless you need to setup a connection for
another TE.
• The APN is read from the USIM card and is usually not changed unless you have more
than one APN provisioned on the USIM card.
• Next, select the QoS that is needed by selecting it from the drop down list.
• If your Service Provider requires a UN and PW, enter it in the Username and Password
boxes, then click on “Apply”.
• The new connection will show up in the table above (See screen shot below for
example).
Background Context activated for 192.168.128.101