Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B
Testing picocells 6–9
5. Select Btsm → State to display the Select BTS window.
6. Select the scanning picocell from the dropdown menu.
7. Verify that the scanning picocell self–test and software
download are successful:
a. BTC: Select each BTC (using the dropdown menu)
and verify that 0 appears in the chan window.
b. WBSU State: Verify that the state is Active.
c. Close the window and return to the WOS BSC
Application window.
8. Minimize the WOS BSC Application window to return to
the AIReach Office window.
Do not close the WOS BSC Application window. This
window is required during normal operation. (If you
inadvertently close this window, it will restart
automatically.)