Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B 6–20 Testing picocells
This section explains how to provision test mobile phones so they
can be used to check traffic picocells.
Multiple users can access and use subscriber configuration
windows at the same time.
Enter and verify the subscriber provisioning information.
1. From the AIReach Office window:
a. Select the Configure → Subscribers.
b. Click the Identification tab.
Initially, this window does not contain data.
2. Select the AROSC Name using the pulldown menu.
3. Enter the first test mobile LDN, MIN, and ESN values, then
click Save.
4. Select Subscriber Type: Local.
5. Select Premises Extension: No.
6. Click Save.
6.6
Provisioning test
mobile phones
Subscriber
provisioning