Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B
Connecting to external equipment 8–1
Chapter 8
Connecting to external equipment
This chapter includes:
• Connecting the Controller to the PBX – page 8–2
• Installing the SSL certificate – page 8–4
• Repointing the HLR – page 8–8
• Installing a second LAN card (optional) – page 8–9
• Enabling alarm paging – page 8–11
As shown in Figure 1-2 (page 1–2), the AIReach OS Controller
connects to:
• The customer’s PBX
• The macro cellular system
• The customer’s corporate LAN (optional)
The procedures explained in this chapter are related to these
connections.