Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B 13–4 Troubleshooting
You need to add picocell IP addresses only if the number of
picocell addresses is incorrect, as explained in the previous
section (Checking the IP addresses). Skip this section if the
picocell IP addresses are configured correctly.
If you need to add picocell IP addresses:
1. Select Start → Settings → Control Panel → Network →
Protocols.
This opens the Network window:
2. Select TCP/IP → Properties → IP Address.
3. Highlight the NMS TXn000 LAN adapter <CP.1> from
the Adap
ter pulldown list and click Specify an IP address.
Adding picocell IP
addresses