Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B 1–12 Introduction
The following materials are required:
• Drywall screws
• E–Z Anchor self–drilling drywall anchors (plastic), light
duty
• Wood screws
• RJ–45 connectors
• RJ–11 connectors
• Pull string
• CAT 5 T1 cable
• CAT 5 T1 test cable (minimum 2 each, 6 feet, flipped and
terminated with an RJ–45 connector on each end)
• Cross–connect blocks (i.e. BIX, 66, 110 block)
• Cable ties
A –48 Vdc power supply is required for testing picocells.
Several options are available for system installation:
• The picocells are line powered and use an ac–to–dc power
supply providing –48 Vdc.
• The System Controller can be configured with up to six T1
cards, each supporting four T1 lines to picocells.
• A traffic picocell can be configured with one to four
transceiver cards.
• Picocells can be daisy–chained to one System Controller T1
port or individually connected to a System Controller T1
port.
• The System Controller can be installed as:
- Desktop mount
- Chassis slide mount
- Full rack mount
Required materials
Other requirements
1.6
Configuration
options