Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B 2–10 Adding cards to the System Controller
A fully loaded System Controller has the backplane loaded as
shown in Figure 2-7. In this configuration, four card slots are
unused and available for future functions.
Figure 2-7 Backplane slot assignments: System Controller fully loaded configuration
PCI
9
PCI
8
PCI
7
PCI
6
PCI
5
PCI
4
PCI
3
PCI
2
PCI
1
ISA
1
ISA
2
ISA
3
ISA
4
ISA
5
ISA
6
ISA
7
ISA
8
56K Modem
Spare
Spare
Spare
TX2000 IP
TX2000 SS7
Conf card 2
Conf card 1
Parallel
port
LAN 1
1
LAN 2
Not
used
23456
Quad T1 Cards
G-17009 F 02/24/00
PCI Slots ISA Slots
Slot
number
12345678910111213
14 15 16 17 18 19 20
Slot
type ID
SBC
Spare
Fully loaded
configuration