Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B
Adding cards to the System Controller 2–25
Use the System Controller installation software to:
• Configure a new System Controller
• Configure a replacement card
• Reconfigure a card after moving it to a different slot
For a new System Controller, follow the configuration steps below
after all cards are installed.
If an installed card is replaced or moved, you must follow the
steps in this section to configure or reconfigure it.
Important: For values needed to configure the picocell, see the
site–specific AIReach Office Configuration Report. References to
specified values or parameters in this manual refer to values and
parameters specified in the Configuration Report. For values not
listed in the Configuration Report, use the default values shown in
the software or specified in these instructions.
Follow the steps below to enter basic configuration information
for newly installed cards.
If you are using the standard Controller configuration, with no
additional cards, verify that the standard cards are installed, and
verify the configuration information.
1. At the System Controller, start Windows NT.
2. From the Windows NT desktop, double–click the
AROSHWCf . . . (hardware configuration) icon:
The AIReach OS software displays the AROS System
Management window, shown below:
3. If any AIReach OS applications are running, close them by
clicking Shutdown AROS.
2.8
Configuring System
Controller cards
Specifying basic card
information