Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B
Adding cards to the System Controller 2–31
If you specified a TX2000 card or conference card (in step 9), the
software displays this window, which shows parameters for
configuring the TX2000 card or conference card:
14. Select the TX2000 or conference card from the Card Type
dropdown list.
15. Verify the displayed values.
16. Select INS from the Desired State menu.
17. Click Accept to save the information.
18. After adding cards or modifying any settings under the HW
Config tab, click Start → Shut Down to reboot the
Controller.
Adding a TX2000 or
conference card