Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B 3–6 Installing the Controller
5. Provide power to the monitor and System Controller (110
Vac, 60 Hz). Figure 3-3 shows the Controller power
connector.
6. Verify that the System Controller power indicators are lit.
The power indicators on the front and rear of the Controller
are on only if power is connected to the Controller and the
front panel power switch is on.
To check System Controller operation:
1. Power on the System Controller.
2. Verify that the Controller successfully boots up. You should
see the Windows NT desktop on the monitor, with no error
messages.
If the Controller does not boot, make sure all cards in the
Controller are properly seated.
3. Verify that the keyboard, touchpad, and monitor are
operational.
4. As the System Controller becomes operational, several
background processes appear on the Windows taskbar.
Verify that the AIReach OS software applications are
present, as indicated on the Windows taskbar:
The taskbar may show other applications in addition to
those shown here.
(The taskbar is shown vertically here; typically, it appears
horizontally across the bottom of the screen.)
3.4
Checking System
Controller operation