Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B
Verifying the System Controller configuration 4–15
When you enter the serial number (from the label on the
back of each picocell), you must enter the serial number
exactly as it appears on the label—as indicated in figure
4-1. If the serial number is entered incorrectly, the picocell
may not operate correctly.
AVPU-D--02025234
T0001001
Include 1 dash
the revision letter.
before
Include 2 dashes
the revision letter.
after
Picocell
revision letter
Enter all 8
digits, including
leading zeros,
as on the label.
Serial number
Figure 4-1 Recording and entering the serial
number from the back of the picocell
4. When you have verified all data in the BTS Configuration –
New window. click Accept.