Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B 4–20 Verifying the System Controller configuration
5. Click the BSC Configuration tab.
6. Enter or verify the information.
Make sure all traffic picocells to be installed are assigned a
BSC.
Verify that all enabled BSC RNUM values are greater than
zero and match the Registration Number entered in the Cell
Configuration – New window (shown on page 4–12).
7. Click Save.
8. Click the MSC Timer tab.
9. Enter or verify the information.
Use the scrollbar to view all fields.
10. Click Save.
11. Click the TLDN Range tab.
A temporary local directory number (TLDN) enables a
macro user to communicate with a mobile registered on the
Controller.
The TLDN maximum range is 100 numbers.
The TLDN cannot be a duplicate of an LDN.
12. Enter or verify the information; then click Save.
13. Click Close to return to the AIReach Office window.