Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B
Verifying the System Controller configuration 4–21
Configure the HLR (Home Location Register) as follows:
1. From the AIReach Office window, select Configure →
NSS → HLR to display the HLR Configuration window.
(This window initially contains no data.)
Note
You only need to configure the HLR once (not once for each
picocell).
2. Select the AROSC Name from the dropdown menu and
enter the specific values. Then click the Save button.
3. Select the NPA–Nxx tab.
You must configure the NPA–Nxx before you can enter the
premises dialing plan.
4. Enter the appropriate values, then click Save.
5. Select the Premises Dialing Plan tab.
6. Enter the appropriate values, then click Save.
Configuring the HLR