Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B
Testing picocells 6–1
Chapter 6
Testing picocells
This chapter includes the following topics:
• Connecting a picocell for testing – page 6–2
• Verifying software load – page 6–5
• Checking scanning picocell operation – page 6–6
• Performing a test frequency band scan – page 6–10
• Checking traffic picocell operation – page 6–17
• Provisioning test mobile phones – page 6–20
• Programming test mobile phones – page 6–22
• Registering test mobile phones – page 6–23
• Placing test calls – page 6–24
• Additional phone programming procedures – page 6–26
Each picocell is tested at the System Controller location (staging
area), so that if a unit fails, it can be replaced before installation.
First you test the scanning picocell, then you test the traffic
picocells.
Important: References to specified values or parameters in this
manual refer to values and parameters specified in the AIReach OS
Configuration Report. For values not listed in the Configuration
Report, use the default values shown in the software or specified
in these instructions.