User Manual Model number: WR3200 1
WI-FI RF FREQUENCY BANDS AND PERFORMANCE The Module shall be compliant with the 802.11n (2.4GHz band) and 802.11ac (5GHz band) Wi-Fi standards. The Module shall be compliant with the 802.11ax (2.4GHz band and 5GHz band) Wi-Fi standard. The Module shall cover an unobstructed indoor range of Vertical 15M and Horizontal 50M.
Setup SOP: EUT LAN IP：192.168.42.1 EUT WiFi 2.4G SSID：HUGHES_24G EUT WiFi 5G SSID：HUGHES_5G 1. The is currently connected to the Test Board(simulation of end-product), please connect the Test Board to the Adapter to power on the EUT 2. Set NB1 WiFi IP to 192.168.42.x1, and connect to module 2.4G SSID through WiFi function (connection password: xxxxxxxx) 3. Set the NB2 WiFi IP to 192.168.42.x2, and connect to the SSID of module 5G through the WiFi function (connection password: xxxxxxxx) 4.
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This module is intended for OEM integrators only. Per FCC KDB 996369 D03 OEM Manual v01 guidance, the following conditions must be strictly followed when using this certified module: KDB 996369 D03 OEM Manual v01 rule sections: 2.
same type with equal gain may also be used with this module. The antenna must be installed such that 20 cm can be maintained between the antenna and users. Lower gain antennas are not permitted without C2PC for devices with radar detection. Antenna Type Dipole Antenna connector i-pex(MHF) 2.8 Label and compliance information The final end product must be labeled in a visible area with the following: “Contains FCC ID: RAXWR3200”.
Manual Information To the End User The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the user’s manual of the end product which integrates this module. The end user manual shall include all required regulatory information/warning as show in this manual. OEM/Host manufacturer responsibilities OEM/Host manufacturers are ultimately responsible for the compliance of the Host and Module.
Antenna Location : ANT set 1： 8
