Product Specs

ManualsBrandsHui Zhou Gaoshengda Technology ManualsElectronicsWIFI+BT Module

Hui Zhou Gaoshengda Technology Co., LTD DCT2RM2501

PAGE 2 OF 3

Version 1.0

NOTICE:

◆please keep this product and accessories attached to the places which children can't touch;

◆do not splash water or other liquid onto this product, otherwise it may cause damage;

◆do not put this product near the heat source or direct sunlight, otherwise it may cause deformation or

malfunction;

◆please keep this product away from flammable or naked flame;

◆please do not repair this product by yourself. Only qualified personnel can be repaired.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part

15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in

a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired

operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the

user’s authority to operate the equipment.

Please notice that if the FCC identification number is not visible when the module is installed inside another

device, then the outside of the device into which the module is installed must also display a label referring to the

enclosed module. This exterior label can use wording such as the following: “Contains FCC ID:2AC23-DCT2R”

any similar wording that expresses the same meaning may be used.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This

equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

The module is limited to OEM installation ONLY.

The OEM integrator is responsible for ensuring that the end-user has no manual instruction to remove or install

module.

The module is limited to installation in mobile application.

A separate approval is required for all other operating configurations, including portable configurations with

respect to Part 2.1093 and difference antenna configurations.

There is requirement that the grantee provide guidance to the host manufacturer for compliance with Part 15B

requirements.

The module complies with FCC Part 15.247 / Part 15.407 and apply for Single module approval.

Trace antenna designs: Not applicable.

Antennas:

2.4G

PCB antenna & 2.5 dBi

PCB antenna & 4.3 dBi

BT Antenna:

BRADE

TYPE

GAIN

GSD

PCB antenna

-4.6 dBi

The antenna is permanently attached, can’t be replaced.