Product Specs

Hui Zhou Gaoshengda Technology Co., LTD WCTA1M2501
PAGE 2 OF 4
Version 1.0
◆do not splash water or other liquid onto this product, otherwise it may cause damage;
◆do not put this product near the heat source or direct sunlight, otherwise it may cause
deformation or malfunction;
◆please keep this product away from flammable or naked flame;
◆please do not repair this product by yourself. Only qualified personnel can be repaired.
FCC S
tatement
FCC standards: FCC CFR Title 47 Part 15 Subpart C Section 15.247 and FCC CFR Title 47 Part
15 Subpart E Section15.407: 2016
FCC Regulatory Compliance:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
If power exceeds the limit and the distance(Over 20cm distance in actual use between the device
and user) is compliance with the requirement.
RF Exposure Compliance:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20cm
between the radiator and any part of your body.
Notice to OEM integrator If the FCC ID is not visible when the module is installed inside another
device, then the outside of the device into which the module is installed must also display a label
referring to the enclosed module. The end product shall haves the words “Contains Transmitter
Module FCC ID: 2AC23-WCTA1”.
The device must be professionally installed.
The intended use is generally not for the general public. It is generally for industry/commercial
use.
The connector is within the transmitter enclosure and can only be accessed by disassembly of the
transmitter that is not normally required. The user has no access to the connector.
Installation must be controlled. Installation requires special training.
Any company of the host device which installs this modular with unlimited modular approval
should perform the test of radiated & conducted emission and spurious emission, etc. according to
FCC part 15C: 15.247 and15.209 & 15.207, 15B Class B requirement, only if the tests result
comply with FCC part 15C: 15.247 and 15.209 & 15.207, 15B Class B requirement, then the host
can be sole legally.