User Manual
Table Of Contents
- 1. Product Overview
- 1.1 Display Introduction
- 1.2 Product and Accessories
- 1.3 Connected to Computer
- 1.3.1 Connected with 3-in-1 Cable
- 1.3.2 Connected with USB-C to USB-C Cable
- 1.4 Driver Installation
- Windows 7 or later，macOS 10.12 or later
- 1.5 Connected to Android Phone/Tablet
- As shown in the figure above, connecting your Andr
- 1.6 Pen Nib Replacement
- 2. Product Basic Operation
- 2.1 Using The Pen
- 2.2 Using the Display
- 2.3 OSD Function
- 3. Function Setting
- 3.1 Device Connection Prompt
- 3.2 Working Area Setting
- 3.3 Press Keys Function Setting
- 3.4 Pen Button Setting
- Select the function to be achieved on the pop-up d
- 3.5 Pressure Sensitivity Setting
- 3.6 Pen Pressure Testing
- 3.7 Calibration
- 3.8 Enable the Windows Ink feature
- 3.9 Data Export and Import
- 4. Specifications
- 5. Trouble Shooting
- 5.1 Possible Breakdowns Related to DISPLAY
- Power indicator does not flash
- *Make sure power is on *Check the socket and po
- No display on the screen
- 1. Make sure power is on.
- 2. Correctly connect the 3-in-1 cable.
- 3. If you connect the display with a laptop, pleas
- 4. Check whether the side indicator shows green, i
- 5. Is the signal wire broken or bent? If so, pleas
- Images are blurred
- Please set the display resolution with 1920 x 1080
- Lack of colors
- Check the pins of the signal wire are not bent or
- There is chromatic aberration
- As the regional color temperature is different, so
- Images jitter or ripple images appear
- It is likely that there is electric equipment near
- 5.2 Possible Breakdowns Related to FUNCTIONS
- 6. After-service Contact
Kamvas 13
11
/ 19 www.huion.com
Exit OSD Menu:
3. Press K4 & K5 again for around three seconds until the OSD menu disappears, the
function of K2 K3 K6 K7 will become shortcuts function again.
3. Function Setting
3.1 Device Connection Prompt
1.Device disconnected: The display hasn’t connected to your computer.
2.Device connected: The display has already connected to your computer.
3.2 Working Area Setting
3.2.1 Using Multiple Monitors
When the KAMVAS Display and other monitors are used in the same system, the
movement of the screen cursor on the standard display depends on the system
configuration. If the secondary display is a mirrored mode connection, this display
and another monitor will display exactly the same image and screen cursor
movement. If you are in the extended display mode, you need to set the display on
the driver that which portion of the display screen your KAMVAS will map to.