User Manual
Table Of Contents
- 1. Product Overview
- 1.1 Display Introduction
- 1.2 Product and Accessories
- 1.3 Connected to Computer
- 1.3.1 Connected with 3-in-1 Cable
- 1.3.2 Connected with USB-C to USB-C Cable
- 1.4 Driver Installation
- Windows 7 or later,macOS 10.12 or later
- 1.5 Connected to Android Phone/Tablet
- As shown in the figure above, connecting your Andr
- 1.6 Pen Nib Replacement
- 2. Product Basic Operation
- 2.1 Using The Pen
- 2.2 Using the Display
- 2.3 OSD Function
- 3. Function Setting
- 3.1 Device Connection Prompt
- 3.2 Working Area Setting
- 3.3 Press Keys Function Setting
- 3.4 Pen Button Setting
- Select the function to be achieved on the pop-up d
- 3.5 Pressure Sensitivity Setting
- 3.6 Pen Pressure Testing
- 3.7 Calibration
- 3.8 Enable the Windows Ink feature
- 3.9 Data Export and Import
- 4. Specifications
- 5. Trouble Shooting
- 5.1 Possible Breakdowns Related to DISPLAY
- Power indicator does not flash
- *Make sure power is on *Check the socket and po
- No display on the screen
- 1. Make sure power is on.
- 2. Correctly connect the 3-in-1 cable.
- 3. If you connect the display with a laptop, pleas
- 4. Check whether the side indicator shows green, i
- 5. Is the signal wire broken or bent? If so, pleas
- Images are blurred
- Please set the display resolution with 1920 x 1080
- Lack of colors
- Check the pins of the signal wire are not bent or
- There is chromatic aberration
- As the regional color temperature is different, so
- Images jitter or ripple images appear
- It is likely that there is electric equipment near
- 5.2 Possible Breakdowns Related to FUNCTIONS
- 6. After-service Contact
Kamvas 13
8
/ 19 www.huion.com
2. Product Basic Operation
2.1 Using The Pen
2.1.1 Hold the pen
Hold the pen as you hold a normal pen or pencil. Adjust your grip so that you can
toggle the side switch easily with your thumb or forefinger. Be careful not to
accidentally press the switch while drawing or positioning with the pen.
Notice: When not in use, place the pen in the pen case or on the desk. Do not place
the pen on the surface of screen, which may interfere with the use of other screen
cursor positioning equipment, it may also cause your computer unable to enter the
sleep mode.
2.1.2 Position the cursor
Move the pen slightly above the active area without touching the screen surface,
the cursor will move to the new position accordingly.
Press the pen tip on the screen to make a selection. Tap the screen once with the
pen tip, or touch it to the screen with enough pressure to register a click.