User Manual
Table Of Contents
- 1. Product Overview
- 1.1 Display Introduction
- 1.2 Product and Accessories
- 1.3 Connected to Computer
- 1.3.1 Connected with 3-in-1 Cable
- 1.3.2 Connected with USB-C to USB-C Cable
- 1.4 Driver Installation
- Windows 7 or later,macOS 10.12 or later
- 1.5 Connected to Android Phone/Tablet
- As shown in the figure above, connecting your Andr
- 1.6 Pen Nib Replacement
- 2. Product Basic Operation
- 2.1 Using The Pen
- 2.2 Using the Display
- 2.3 OSD Function
- 3. Function Setting
- 3.1 Device Connection Prompt
- 3.2 Working Area Setting
- 3.3 Press Keys Function Setting
- 3.4 Pen Button Setting
- Select the function to be achieved on the pop-up d
- 3.5 Pressure Sensitivity Setting
- 3.6 Pen Pressure Testing
- 3.7 Calibration
- 3.8 Enable the Windows Ink feature
- 3.9 Data Export and Import
- 4. Specifications
- 5. Trouble Shooting
- 5.1 Possible Breakdowns Related to DISPLAY
- Power indicator does not flash
- *Make sure power is on *Check the socket and po
- No display on the screen
- 1. Make sure power is on.
- 2. Correctly connect the 3-in-1 cable.
- 3. If you connect the display with a laptop, pleas
- 4. Check whether the side indicator shows green, i
- 5. Is the signal wire broken or bent? If so, pleas
- Images are blurred
- Please set the display resolution with 1920 x 1080
- Lack of colors
- Check the pins of the signal wire are not bent or
- There is chromatic aberration
- As the regional color temperature is different, so
- Images jitter or ripple images appear
- It is likely that there is electric equipment near
- 5.2 Possible Breakdowns Related to FUNCTIONS
- 6. After-service Contact
Kamvas 13
15
/ 19 www.huion.com
3.6 Pen Pressure Testing
You can gradually apply pressure to the stylus on the screen to test the pressure
level. Click “Clear” button to clear all the ink.
3.7 Calibration
Screen Calibration: Click the red point of the cross center appearing on the screen
to complete the calibration.
Restore Factory Settings: Click "Restore Default" to restore to the factory settings.
Cancel Calibration: Click"Cancel calibration” or press ESC on the keyboard to
cancel the calibration.