User Manual
Table Of Contents
- 1. Product Overview
- 1.1 Tablet Introduction
- 1.2 Product and Accessories
- 1.3 Tablet Connection
- 1.4 Driver Installation
- Windows 7 or later,macOS 10.12 or later
- 1.5 Pen Nib Replacement
- 2. Product Basic Operation
- 2.1 Using The Pen
- 2.2 Using the Tablet
- 3. Function Setting
- 3.1 Device Connection Prompt
- 3.2 Working Area Setting
- 3.3 Press Keys Function Setting
- 3.4 Pen Buttons Function Setting
- Select the function to be achieved on the pop-up d
- 3.5 Pressure Sensitivity Setting
- 3.6 Pen Pressure Testing
- 3.7 Enable the Windows Ink feature
- 3.8 Data Export and Import
- 4.Specifications
- 5.1 Possible Breakdowns Related to TABLET
- There is no pressure in the graphics software but
- You may have installed other tablet drivers or ope
- While using the tablet, the battery indicator flas
- The battery voltage is low, please recharge the ta
- The pen does not work
- 1. Make sure you are using the pen that originally
- 2. Make sure you installed the driver correctly.
- Press Keys does not work
- 1. Make sure the Press Keys function were enabled
- The cursor is not stable or the drawing line is no
- 1. Make sure there is no other 2.4G device surroun
- The computer can’t enter sleep mode
- When you are not using the tablet, please do not p
- 5.2 Possible Breakdowns Related to SYSTEM
- 6. CE and FCC Notice
- 7. After-service Contact
WH1409 V2 Wireless Graphics Tablet
9
/ 18 www.huion.com
2.2 Using the Tablet
2.2.1 Power Switch
1. The power switch was placed on the top left side of the tablet, when you use the
tablet on wireless mode, you need to turn on the power switch before using.
2. When not use the tablet for 15 minutes or toggle the switch off, it will enter sleep
mode.
3. LED indicator:
2.2.2 Press Keys
There are 12 press keys on the left side of the tablet, which you can set the function
on the driver interface according to your own habits, which will help to improve
your work efficiency.
2.2.3 Charging the Tablet
1. Before using the tablet for the first time in wireless mode, you should fully charge
the tablet battery. Do this by connecting the USB cable between tablet and a
primary USB port on your computer, or to a powered USB port.
2. The USB cable is used for charging the battery, and also for operating the tablet
as a wired USB tablet. The battery will charge whenever the USB cable is connected
and the battery is not fully charged.
3. It will take about 7 hours to fully charge an empty battery. The actual charge time
depends on current battery level and tablet use while charging. The battery status
indicator shows RED when charging, and will be OFF when fully charged.
4. Whenever the tablet is connected to computer with USB cable, the wireless mode
will be disabled.
Pen or press key working
Wireless Mode
Tablet in charge, light off when fully charged
Low voltage