User Manual
Table Of Contents
- 1. Product Overview
- 1.1 Tablet Introduction
- 1.2 Product and Accessories
- 1.3 Tablet Connection
- 1.4 Driver Installation
- Windows 7 or later,macOS 10.12 or later
- 1.5 Pen Nib Replacement
- 2. Product Basic Operation
- 2.1 Using The Pen
- 2.2 Using the Tablet
- 3. Function Setting
- 3.1 Device Connection Prompt
- 3.2 Working Area Setting
- 3.3 Press Keys Function Setting
- 3.4 Pen Buttons Function Setting
- Select the function to be achieved on the pop-up d
- 3.5 Pressure Sensitivity Setting
- 3.6 Pen Pressure Testing
- 3.7 Enable the Windows Ink feature
- 3.8 Data Export and Import
- 4.Specifications
- 5.1 Possible Breakdowns Related to TABLET
- There is no pressure in the graphics software but
- You may have installed other tablet drivers or ope
- While using the tablet, the battery indicator flas
- The battery voltage is low, please recharge the ta
- The pen does not work
- 1. Make sure you are using the pen that originally
- 2. Make sure you installed the driver correctly.
- Press Keys does not work
- 1. Make sure the Press Keys function were enabled
- The cursor is not stable or the drawing line is no
- 1. Make sure there is no other 2.4G device surroun
- The computer can’t enter sleep mode
- When you are not using the tablet, please do not p
- 5.2 Possible Breakdowns Related to SYSTEM
- 6. CE and FCC Notice
- 7. After-service Contact
WH1409 V2 Wireless Graphics Tablet
7
/ 18 www.huion.com
2. Product Basic Operation
2.1 Using The Pen
2.1.1 Hold the pen
Hold the pen as you hold a normal pen or pencil. Adjust your grip so that you can
toggle the side switch easily with your thumb or forefinger. Be careful not to
accidentally press the switch while drawing or positioning with the pen.
Notice:When not in use, place the pen in the pen case or on the desk. Do not place
the pen on the surface of screen, which may interfere with the use of other screen
cursor positioning equipment, may also cause your computer can not enter the
sleep mode.
2.1.2 Position the cursor
Move the pen slightly above the active area without touching the screen surface,
the cursor will move to the new position accordingly.
Press the pen tip on the screen to make a selection. Tap the screen once with the
pen tip, or touch it to the screen with enough pressure to register a click.