User's Manual
Table Of Contents
- FEATURES
- CONTROLS AND INDICATORS
- REMOTE CONTROL
- USING THE TFT MONITOR
- EXTERNAL DEVICES
- QUICK START GUIDE
- EQUALIZER CONTROL MENU
- SYSTEM SETTINGS
- DISC OPERATION
- RADIO TUNER OPERATION
- USB OPERATION
- iPod®/iPhone® OPERATION
- AV-In1/AV-In2 OPERATION
- BLUETOOTH OPERATION
- NAVIGATION QUICK START GUIDE
- REAR CAMERA OPERATION
- STEERING WHEEL CONTROLS (SWC) OPERATION
- PANDORA RADIO OPERATION
- SiriusXM® RADIO OPERATION
- CARE AND MAINTENANCE
- SPECIFICATIONS
- NOTES
73
VX7014
SWC Programing
Up to 16 steering wheel control functions can be programmed via the built-in
SWC interface. Not all functions may be supported for each vehicle.
1. Popular OE steering wheel functions are already pre-programmed from the
factory. If your vehicle does not support the exact same functions already pre-
programmed, you will need to clear / reset the SWC interface and program
in the exact functions of your vehicle. To clear / reset the SWC interface, press
and hold “Reset” for 2 seconds.
2. To begin programming the SWC interface after it has been cleared / reset,
press a key 1 ~ 16, then press a function. The name of the selected function
should appear next to the Key number programmed (Key 1 Volume +,
etc.).Continue programming in this manner until all of the OE steering wheel
control functions are completed.
Note: Functions 1 ~ 16 must be assigned to a function on the OE steering wheel.
For example, if the OE steering wheel does not support Preset + and
Preset -, then these functions must be cleared / reset in order for the other
functions to work correctly.
3. To “learn” the programming completed in step 2 above, press the “Learn” icon.
You will then be prompted to push each button on the OE steering wheel (for
1 second), so the unit can learn the corresponding function.
4. SWC learning / programming is now complete.